1487
Stage 3 – Re-register All keys:
1. Navigate to Chassis Diagnostics.
2. Press the motorcycle's Power button (Note: the motorcycle will nor appear to
power ON).
3. Within 10 seconds, click Immobiliser Diagnostics.
4. In the Configure tab, click Re-register all keys.
5. Pair the Smart key first, followed by the two passive keys.
Stage 4 - Pair the Electronic Steering Lock (if fitted).
Stage 5 - Full Keyless ECM download:
1. Make sure a paired key is in range and turn the ignition ON. The instruments and
headlight should now turn ON.
2. Complete a full keyless ECM download using the normal download method.
3. Follow all on-screen instructions during the download.
4. Click Finish when the download has completed.
Stage 6 - Pair the Engine ECM with the Immobiliser:
1. Switch the engine start/stop switch to the RUN position.
2. Navigate to Immobiliser Diagnostics and pair the engine ECM and immobiliser.
Stage 7 - Final Steps:
1. Turn the ignition off for at least 60 seconds.
2. Check the ignition can be turned ON and engine started using each key.
3. Check all ECMs for stored DTCs and erase as necessary.
To Next Page
Loading...
