1514
Gear Position Adaption
Gear position adaption is required to allow for manufacturing tolerances of the gearbox
and gear position sensor.
If Triumph Shift Assist is fitted as standard, the motorcycle is delivered from the factory
with each gear position fully adapted.
If the Triumph Shift Assist has been fitted as an accessory, each gear position must be
fully adapted as part of the accessory kit installation process.
Gear position adaption must be reset and re-adapted under the following conditions:
• If a gear position sensor malfunction occurs (DTC P0914 and P0917, see).
• The gear position sensor has been removed or disconnected for any reason.
Adaption Reset
The Gear Position/Neutral Position Adaption Reset function provided in the Triumph
diagnostic tool will erase all previous Gear Position/Neutral Position Adaptions.
To reset the Gear Position/Neutral Position adaptions:
1. Connect the Triumph diagnostic tool and turn the ignition ON.
2. Select ENGINE DIAGNOSTICS.
3. Check and erase any stored DTCs.
4. Select ADJUST TUNE then select Gear Position/Neutral Position Adaption Reset.
5. Click Start.
6. The software will confirm that the adaption has been successfully reset.
7. The neutral position and each gear position will now be reported as Not Adapted.
To Next Page
Loading...
