211
Check the functionality of all following actions:
• SET the speed
• Resume the SET speed
• Increase the SET speed
• Decrease the SET speed
• Throttle cancel - twist the throttle fully forward to cancel the cruise control
• Brake cancel - make sure the cruise control is cancelled by use of the front brake,
then the rear brake
• Clutch cancel - make sure the cruise control is cancelled by pulling the clutch lever in
• Gear change cancel - make sure the cruise control is cancelled when changing gear
• Sixty second overtake cancel - make sure the cruise control is cancelled after
increasing the speed with the throttle for more than sixty seconds.<
Service Indicator and Service Maintenance Book
Reset the service indicator using the Triumph Diagnostic Tool.
See the Triumph Diagnostic Tool User Guide for more information.
Stamp and date the relevant section of the Service Record.
Post Road Test
The following tests should be carried out immediately after the motorcycle returns
from the road test.
Faults detected during road test or post road test inspection, must be rectified before
the motorcycle is released to the customer.
To Next Page
Loading...
