Note the orientation of the camshaft cover and spark plug tower gaskets for
installation.
10. Remove and discard the camshaft cover gasket and the spark plug tower gasket.
11. Remove any residual oil from the mating face of the cylinder head using a lint free
cloth.
Camshaft Cover – Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
1. Fit a new camshaft cover seal to the camshaft cover as noted for removal.
2. Fit a new spark plug tower seal to the cylinder head as noted for removal.
3. Check to make sure the secondary air injection dowels and their O-rings are fitted to
the cylinder head not the camshaft cover.
4. Position the camshaft cover to the cylinder head. Make sure that the gasket remains
in position.
Fit the brackets to the front and rear of the camshaft cover as noted for removal.
Make sure the two M6 x 55 mm fixings and their washers are fitted between cylinders
one and two spark plugs.
5. Fit the fixings as noted for removal and tighten the camshaft cover fixings in the
following three stages:
To Next Page
Loading...
