Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
1. Thoroughly clean the cover and crankcase mating faces.
2. Make sure the dowels are fitted as noted for removal.
3. Position a new gasket to the crankcase.
4. Refit the cover ensuring that the gasket does not become dislodged.
5. Fit the fixings and tighten in the following two stages:
Stage 1
6. Tighten the fixings one to fifteen in the sequence shown to 10 Nm.
To Next Page
Loading...
