Note the order and orientation of each component as it is removed. It is essential for
correct clutch operation that each component is installed in the correct order and
orientation during reassembly.
The following items can be replaced on the clutch master cylinder.
• Clutch fluid reservoir
• Lever
Clutch Fluid Reservoir
1. Remove the master cylinder (see Clutch Master Cylinder - Removal).
2. Release the fixings and remove the reservoir cap, sealing plate and diaphragm seal.
3. Remove the sealing screw from the reservoir mounting fixing.
4. Remove the mounting fixing with its two O-rings.
1. Sealing screw
2. Fixing
3. Clutch fluid reservoir
To Next Page
Loading...
