363
4. Attach the clutch switch assembly to the master cylinder as noted for removal.
1. Clutch switch
2. Securing lugs
3. Location holes
5. If removed, refit the clutch lever. Tighten the pivot bolt to 6 Nm and the nut to 6 Nm.
6. Bleed the clutch (see Bleeding the Clutch).
7. Check the clutch for correct operation and fluid leaks. Rectify as necessary.
Clutch Slave Cylinder – Removal
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
To Next Page
Loading...
