Use only DOT 4 specification brake fluid as listed in the General Information section of
this manual. The use of brake fluids other than those DOT 4 fluids listed in the General
Information section may reduce the efficiency of the braking system leading to an
accident.
Failure to change the brake fluid at the interval specified in the routine maintenance
schedule may reduce braking efficiency resulting in an accident.
Never use mineral-based grease in any part of the braking system or in any area where
contact with the braking system is possible. Mineral-based grease will damage the
hydraulic seals in the calipers and master cylinders.
Damage caused by contact with mineral-based grease may reduce braking efficiency
resulting in an accident.
Before installation, all internal brake components should be cleaned and lubricated
with clean new DOT 4 brake fluid.
Never use solvents, petrol (gasoline), engine oil or any other petroleum distillate on
internal brake components as this will cause deterioration of the hydraulic seals in the
calipers and master cylinders.
A dangerous riding condition leading to loss of motorcycle control and an accident
could result if this warning is ignored.
To Next Page
Loading...
