409
Sealer Areas
4. Position the transmission cover to the upper crankcase.
5. Fit a new copper washer to the M8 x 65 mm fixing (item1 in the tightening
sequence).
6. Fit the bolts into the transmission cover as noted for removal and hand tighten until
the bolt heads are near contact with the crankcase.
7. Tighten the transmission cover fixings in the following three stages:
Stage 1
8. Tighten the fixings 1 to 14 in the sequence shown to 10 Nm.
Stage 2
9. Tighten the fixings 1 to 4 in the sequence shown to 32 Nm.
Stage 3
10. Tighten the fixings 5 to 14 in the sequence shown to 12 Nm.
Transmission Cover Tightening Sequence
To Next Page
Loading...
