Triumph Rocket 3 GT 2021 - Page 558

530
11. Fit the oil pump front end cap and the three bolts as noted for removal.
12. fit the locknuts and tighten to 5 Nm.
1. Fixings
2. Lock nuts
3. Front end cap
Oil Pump – Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
Perform the following operations:
1. Use high flash-point solvent to clean the crankcase and oil pump mating faces. Wipe
the surfaces clean with a lint-free cloth.