Triumph Rocket 3 GT 2021 - Page 592

564
53. Fit two new O-rings to the gear position sensor. Lubricate the O-rings with a smear of
petroleum jelly.
54. it the gear position sensor to the engine. Make sure that the locating pin on the
sensor fits into the hole in the end of the gear selector drum.
1. Locating pin
2. Hole
55. Fit the gear position sensor fixings and tighten to 10 Nm.
56. Attach the side stand switch to the side stand assembly and tighten the new fixings
to 3 Nm.
1. Fixings
2. Side stand switch