568
63. Fit a new clutch slave cylinder gasket.
64. If fitted remove the rubber band or cable tie securing the piston to the slave cylinder.
65. Fit the clutch slave cylinder as noted for removal and tighten its fixings to 10 Nm.
66. Fit two new sealing and tighten the clutch hose union bolt to 25 Nm.
67. Bleed the clutch (see Bleeding the Clutch).
68. Check the clutch for correct operation and fluid leaks. Rectify as necessary.
69. Fit the clutch cover finisher and secure with the single fixing as noted for removal. Do
not fully tighten the fixing at this stage.
1. Fixings
2. Clutch cover finisher
To Next Page
Loading...
