597
Engine Management Adaption
After the engine management adaption has been reset on this model, the Cruise
Control Switch Check Function Test must be performed (see Cruise Control Switch
Check). After the adaptions have been reset, DTC 1575 (cruise control disabled until
button press sequence completed) will be stored, and the cruise control disabled, until
the function test is completed.
General Information
The engine management system fitted to this model is adaptive. This means that the
system is able to learn about new or changing operating conditions and continuously
adapt itself without needing to constantly make major adjustments from a fixed baseline
setting.
Adaptive changes can become necessary because of changing rider behaviour, changes
in the region in which the bike is operated (i.e. operation at high altitude where it was
previously used at sea level) or because a new part may have been fitted which has
slightly different characteristics to the old part. All adaptive changes are automatic and
require no intervention by rider or dealer.
Adaption Status
To see if a motorcycle has fully adapted, a facility named 'ADAPTION STATUS' is
provided on the diagnostic tool. The following adaption details can be examined:
Closed throttle position reference status
Idle speed control adaption status
Oxygen sensor adaption status (off idle)
Oxygen sensor adaption range (off idle)
Oxygen sensor adaption status (idle)
Oxygen sensor adaption range (idle)
To Next Page
Loading...
