599
Forcing Adaption to Take Place
If the read out indicates that the motorcycle is not adapted, the following will force the
system to make adaptions:
Never start the engine or let it run for any length of time in a closed area. The exhaust
fumes are poisonous and may cause loss of consciousness and death within a short
time. Always operate the motorcycle in the open-air or in an area with adequate
ventilation.
Resetting adaptions with the motorcycle connected to an exhaust extraction system
may cause incorrect values to be set, causing poor engine running. Always reset the
adaptions with the engine disconnected from any exhaust extraction system whilst
ensuring the motorcycle is positioned in a well ventilated area.
1. Make sure the engine is cold.
2. WITHOUT TOUCHING THE THROTTLE, start the engine and allow it to warm up until
the cooling fan comes on.
3. Leave the engine to idle for a further 12 minutes.
As an alternative to the above process, connect the diagnostic tool, select ADJUST
TUNE (see the Triumph Diagnostic Tool User Guide) and select RESET ADAPTIONS.
This will force a fast adaption routine to take place in around five seconds. For this to
happen, the engine MUST be running, it must be at normal operating temperature and
in closed loop control mode. Under any other conditions fast adaption will not take
place and may cause default values to be loaded, which may then require a normal 12
minute adaption routine to be run.
To Next Page
Loading...
