841
9. Tighten the catalytic converter centre fixing to 28 Nm
10. Hold the lock nut and tighten the catalytic converter left hand fixing to 28 Nm
11. Hold the lock nut and tighten the catalytic converter right hand fixing to 28 Nm
12. Apply a thin smear of anti-seize compound to the threads of the oxygen sensor twist
the sensor in an a clockwise direction (looking at the sensor)the number of turn
noted for removal. install the oxygen sensor to the catalytic converter and tighten to
25 Nm.
1. Oxygen sensor
13. Start the engine and check for exhaust gas leaks. Rectify if necessary.
14. Fit the cover to the catalytic converter. Make sure the locating lug fit into its its
grommet.
To Next Page
Loading...
