Need help?Do you have a question about the Triumph SPEED TWIN 1953 and is the answer not in the manual?
General| Engine Type | Parallel Twin |
|---|---|
| Transmission | 4-speed |
| Compression Ratio | 7.0:1 |
| Carburetor | Amal Monobloc |
| Front Suspension | Telescopic forks |
| Top Speed | 145 km/h |
| Engine | Air-cooled |
| Gearbox | 4-speed |
| Frame | Steel |
| Rear Suspension | Swingarm |
| Front Brake | 7 in (178 mm) drum |
| Rear Brake | 7 in (178 mm) drum |
Provides detailed technical specifications for the Speed Twin (5T) model.
Provides detailed technical specifications for the Thunderbird (6T) model.
Provides detailed technical specifications for the Trophy (TR5) model.
Provides detailed technical specifications for the Tiger 100 (T100) model.
Provides detailed technical specifications for the Tiger 110 (T110) model.
Details the regular maintenance required for the engine lubrication system.
Describes the gearbox lubrication and maintenance requirements.
Describes the construction and features of the crankcase.
Details the balanced crankshaft and flywheel assembly.
Explains the types and construction of the cylinder block.
Describes the construction of the cylinder head and its parts.
Details tappet adjustment differences for T110 and TR5 models.
Explains how to remove, inspect, and clean rocker boxes.
Details the procedure for removing and inspecting valves and springs.
Explains the removal and inspection of the main bearings.
Guides on assembling the crankshaft into the crankcase.
Details the process of aligning and mating the crankcase halves.
Explains how to correctly set the valve timing using marks.
Details how to perform ignition timing after cylinder head fitting.
Guides on installing the engine into rigid frame models.
Covers the initial positioning and engagement of the engine.
Guides on installing the engine into swinging arm frame models.
Explains how to correctly set the valve timing using marks.
Details the procedure for adjusting tappets to the correct clearance.
Guides on setting ignition timing with a magneto system.
Explains how to position the contact breaker for timing.
Details ignition timing procedures for coil systems.
Explains the gearbox operation and its construction.
Discusses common causes and remedies for faulty gear selection.
Outlines gearbox removal for TR5 models, noting exceptions.
Details gearbox removal for swinging arm frame models.
Guides on initial preparation and disassembly of the gearbox.
Explains the inspection and removal of the gear cluster.
Introduces the process of overhauling the clutch.
Guides on the process of assembling the clutch unit.
Provides instructions for cleaning and greasing the rear chain.
Outlines routine maintenance for the telescopic fork.
Details the procedure for adjusting steering head races.
Guides on assembling and installing the fork on nacelle-type models.
Details the procedure for adjusting front and rear brakes.
Guides on removing the front wheel from the forks.
Details the steps for removing the rear wheel from the frame.
Guides on positioning and fitting the rear wheel into the frame.
Details removing the rear wheel from swinging fork frames.
Guides on removing the Quickly Detachable rear wheel.
Guides on removing the spring wheel from the frame.
Details reassembling the rear spring wheel components.
Explains the importance of correct tyre pressure.
Guides on adjusting and tuning the S.U. carburetter.
Provides troubleshooting steps for an engine that will not start.
Explains the dynamo's function and output control.
Describes the magneto's construction and lubrication.
Provides a general description of the lighting and ignition system.
Explains how to check and adjust the contact breaker setting.
Provides troubleshooting steps for an engine that will not start.
Covers the importance and selection of sparking plugs.
Guides on assembling the 3T crankshaft.
To Next Page