Maintenance and Adjustment
146
Headlight Adjustment
1. Headlight assembly mounting bolt
To adjust the headlight beam:
• Always make sure the handlebars
are in the straight ahead position.
• Vertical adjustment of the headlight
beam is controlled by loosening the
headlight assembly mounting bolts
and altering the position of the
headlight assembly.
• Retighten the headlight assembly
mounting bolts after adjustment to
89 lbf in (10 Nm).
Tail Lights
The LED tail light units are sealed,
maintenance free LED units. The tail
light units must be replaced in the event
of the failure of the tail lights.
Multifunctional Tail Lights
(if equipped)
Bonneville T120 Ace and Speed Twin
The multifunctional tail light units
operate as the rear position light, brake
light and turn signals.
The multifunctional tail light units are a
sealed, maintenance free LED unit and
must be replaced in the event of the
failure of the tail lights.
To Next Page
Loading...
Need help?
General
