Need help?Do you have a question about the Trojan 30 and is the answer not in the manual?
Install LH & RH handle braces to the spreader frame using hex bolts and nuts.
Secure the drive wheel and free wheel to the axle using cotter pins.
Install the handle tube between the handle braces using hex bolts and nuts.
Secure the T-handle and connect the control knob/wire assembly, then latch the knob.
Attach the wire retaining clip to the shutoff plate and wire until it locks.
Install handle grips using soapy water and insert the screen into the hopper.
Check product package for rate setting and swath width, then adjust the rate cam.
Fill spreader on driveway, ensure it's off, then start moving before opening.
Hold spreader level, push at 2.5 mph, and use header strips for even coverage.
Empty spreader after each use and return leftover material to its original container.
Consider product application rate per area and effective pattern width.
Perform a visual test or use cake tins to measure material distribution.
Provides approximate settings and spread widths for various fertilizer particle sizes.
Do not store unused material; wash and dry spreader thoroughly after each use.
Oil axle bearings, impeller shaft bearing, and control knob in the T-handle.
Check gear mesh, clean impeller surface for consistent spread pattern.
Maintain tire pressure between 20-25 PSI for optimal performance.
Install LH & RH handle braces to the spreader frame using hex bolts and nuts.
Secure the drive wheel and free wheel to the axle using cotter pins.
Install the handle tube between the handle braces using hex bolts and nuts.
Secure the T-handle and connect the control knob/wire assembly, then latch the knob.
Attach the wire retaining clip to the shutoff plate and wire until it locks.
Install handle grips using soapy water and insert the screen into the hopper.
Check product package for rate setting and swath width, then adjust the rate cam.
Fill spreader on driveway, ensure it's off, then start moving before opening.
Hold spreader level, push at 2.5 mph, and use header strips for even coverage.
Empty spreader after each use and return leftover material to its original container.
Consider product application rate per area and effective pattern width.
Perform a visual test or use cake tins to measure material distribution.
Provides approximate settings and spread widths for various fertilizer particle sizes.
Do not store unused material; wash and dry spreader thoroughly after each use.
Oil axle bearings, impeller shaft bearing, and control knob in the T-handle.
Check gear mesh, clean impeller surface for consistent spread pattern.
Maintain tire pressure between 20-25 PSI for optimal performance.
To Next Page
General