INSTALLING THE WATER VALVE
Note: The valve supplied with Trone toilets is not a tapered thread and
will need one of the two options listed below.
Option #1: Retro fit with water supply line (easiest method)
1. Turn off toilet supply stop.
2. Remove existing 3/8” x 7/8” toilet supply tube.
3. Attach the provided 3/8” x 1/2” braided faucet water supply
line.
Note: If your existing water supply valve is not 3/8” compression
you will have to source a supply line that can fit on it and adapt to
1/2” NPT.
4. Attach the provided valve stop to the faucet water supply line.
Option #2: Replumb water line supply to pex (new construction,
remodels, and plumber installation. Not recommended without a
professional)
1. Turn water off to the house.
2. Remove current toilet water supply valve.
3. Adapt plumbing to ½” pex either in the wall or outside.
4. Crimp pex swivel female adapter (provided) onto pex.
5. Attach the provided new valve.
Note: For new install rough-in, 5” from finished floor and 10” left of
center for ease and accessibility. It is not recommended to be
placed behind the toilet.
To Next Page