EN 13
wet and dry vacuum cleaner VC 1200W
2. Press the on/off switch(10) to positionII to switch on the
cleaning function with detergent.
ð The device is switched on. You can treat surfaces with
detergent.
Cleaning with detergent
Note
For cleaning with detergent only use the spray floor
nozzle or the spray hand nozzle.
The other nozzles are not provided with a fitting to the
detergent pipe.
Note
Ensure that the detergent tank contains a sufficient
amount of detergent.
Note
Remove the dust bag before cleaning with detergent.
Note
Before cleaning with detergent, remove large dirt
particles so as to prevent the nozzles from being
blocked.
ü The hose(1) is connected to the air intake opening(6), the
detergent pipe(2) is connected to the fitting(22).
1. Attach the desired nozzle as described in the Changing the
nozzles chapter.
2. Switch the device to position II.
3. At the start, keep the spray button on the hose handle(11)
pressed until detergent sprays out of the nozzle.
ð The device is ready for cleaning with detergent.
4. Move the nozzle slowly and steadily over the surface to be
cleaned. Briefly press the spray button on the hose
handle(11) to obtain one single shot of detergent. Keep
the spray button on the hose handle(11) pressed for a
longer time to obtain a continuous flow of detergent.
ð The detergent and dissolved dirt particles are sucked
into the tank(14) via the nozzle.
Suction
Note
Only use the dust bag to vacuum dry dirt! When the
dust bag comes into contact with liquid, it will be
damaged.
ü The hose(1) is connected to the air intake opening(6).
1. Attach the desired nozzle as described in the Changing the
nozzles chapter.
2. Switch the device to position I.
3. Move the nozzle slowly and steadily over the surface to be
cleaned.
ð Air and dirt particles are sucked into the nozzle.
To Next Page
Loading...
Need help?
General