TRT TractionAir - GPS Reciever Mounting; Wiring for the Short Lead on the Loom

TractionAir
5
ECU’s with GPS Speed Control
Ensure the GPS receiver is mounted as close to the windscreen as possible
with a clear view of the sky. This will allow the strongest signal.
Wiring for the Short Lead on the Loom
(Power and Earth to ECU)
Note: Power to be ignition fed.
3
5
1
2
5
6
7
8
9
10
11
12
10 PIN FEMALE PLUG
(To Rear of TractionAir Controller)
2 Core Power (3m) to Ignition
7 Core to Pressure Cell
RED 11 to 30V DC
Black 0V
BLACK (GND)
RED (Drive Inate)
BROWN (POS)
YELLOW (Drive 4-20mA IN)
BLUE (Drive 4-20mA IN)
WHITE (Spare)
GREEN (Drive Exhaust)