1. To Adjust Seat Height:
While seated, lean forward and reach under the right
side of the chair to find the handle. Lift the handle and
raise your body up slightly to allow the chair to rise to
the desired height. To lower the seat, lift the handle
while applying weight downward on the seat. The
chair will descend until the handle is released or the
chair reaches the bottom position.
2. To Operate Tilt Lockout:
While sitting in the chair, the lever on the users left side
controls the tilt lock function. Lift up on the lever to
unlock the tilt function. The chair should tilt freely
through the full range of motion. Press down on lever to
lock the chair in any position. The tilt function can be
locked out in the full upright position, in full recline, or
any position in between.
3. To Adjust Tension on The Tilt:
Reach under the front center of the chair, grasp the
round knob and turn counter - clockwise to make the tilt
mechanism firmer (stiffer). To make the tilt mechanism
less firm, turn the knob clockwise until the desired
resistance is found.
4. To Adjust Mechanical Lumbar:
While seated, reach to the right side of the back
cushion to find the adjustment knob for the mechanical
lumbar. Turn the knob clockwise to increase the lumbar
support. To reduce the lumbar support, turn the knob
counter – clockwise. Turn the knob until the desired
support is reached.
To Next Page
Need help?
General
