Set depth of forstner stop.
Check depth stop collar set screw to assure
it is tight and secure for drilling operations.
Select 2 1/8" (57mm) or 2 1/4" (55mm) Forstner bit.
Place the bit in forstner guide and check drilling depth
for your specific puck light installation requirements.
Be sure to measure depth of the
center brad point of the forstner bit.
Bore your puck light hole using safe drilling practices,
wearing safety glasses and keeping
hands clear of Forstner bit at all times.
Drill 3/8 hole (wire chase) into puck light opening.
CAUTION: When drilling, pull back drill frequently to
remove wood shavings. Do not force drill forward,
excessive force can result in panel blow-out.
When 3/8" drill bit breaks through into puck light
hole, stop drilling forward and remove the drill bit.
Install your wire and puck light.
To Previous Page
Loading...