3EN
A measurement is started by the pressing the measuring head (1)
horizontally onto the gas cylinder (confirmed by a beeping sound).
90°
The status LED (3) flashes orange during the measuring process.
The end of the measurement is indicated via a second beeping
tone and the measuring result is displayed on the status LED (3).
Status LED green – Liquid detected at the measuring point
Status LED red – No liquid or inaccurate measurement
The device switches off automatically after a measurement
has been taken.
LED light
The LED light (2) is switched on by pressing the button (4).
Re-pressing the button switches the LED light off again. The
LED light switches off automatically after around 5 minutes.
Undervoltage / malfunction
– The displayed measuring result flashes: The battery is low
(measurements can still be taken)
– The red status LED flashes and beeps 3 times: The battery is
empty (measurements can no longer be taken)
Battery change
Please only use leak-resistant batteries
(E-Block 9V), Type6 LR61, 6F22.
Unscrew the screw (7) from the lower shell. Push the lower
shell in the direction of the arrow and detach. Replace the
battery and when doing so, check the polarity of the wires.
Dispose of the empty battery correctly and separately from
the device.
An empty spent battery can leak and damage the de-
vice! Remove the battery from the device if the device
is not going to be used for a longer period.
The warranty will not apply to damage caused by leaking
batteries.
Disposal
Neither the appliance nor the batteries may be disposed
of with domestic refuse, instead they must be sent for
recycling separately via a collection point. By doing this
you are contributing towards reuse and recycling.
Technical data
Power supply
E-Block 9 V
Dimensions (W x H x D)
138 x 35 x 30 mm
Weight (incl. battery)
approx. 100 g
The right to effect technical modifications is reserved!
To Next Page
Loading...
