Truma TEB-3 - Fuse Change and TN-3 Operation; Fuse Change (TEB-3 - 12 V); TN-3 - 230 V Operation; Disposal Instructions

9
Fuse change (TEB-3 – 12 V only)
Observe the ESD regulations.
The appliance fuse (F1) is on the electronic control unit in the
appliance.
– Switch fan so that it is voltage-free (disconnect battery, dis-
connect mains plug if necessary).
– Remove connectors from power supply and control panel.
– Remove 2 screws (1) from the housing – take off housing.
– Hold the edges of the PCB and pull it out of the housing.
– Always replace defective fuses with identical fuses (see
“Technical data”).
– Insert PCB into the housing.
– Secure housing to fan with 2 screws (1) after changing the
fuse.
– Attach connectors of control panel and power supply (ob-
serve correct polarity, otherwise the control panel will not
function and the fan will run in the wrong direction).
– Reconnect battery, re-establish mains connection if necessary.
F1
1
TN-3 – 230 V
External control panel
1
2
3
4
5
230 V ~
Trumavent
d
c
a
b
a = Control knob for fan power (1 – 5)
b = Rotary switch for operating modes
c = Off
d = On, manual fan power setting
Set required speed with control knob (a).
Disposal
The appliance must be disposed of in accordance with the ad-
ministrative regulations of the respective country in which it is
used. National regulations and laws (in Germany, for example,
the End-of-life Vehicle Regulation) must be observed.