Need help?Do you have a question about the Truper CALA-A3 and is the answer not in the manual?
Select the correct blade for the material to reduce injury risk and improve speed.
Verify no nails/screws on cutting line and clamp the workpiece securely.
Hold tool by insulated grips, use vice for workpiece, keep hands away from cutting area.
Remove tool from workpiece only when stopped. Avoid stopping blade by side force.
Loosen screws, insert blade fully into support, tighten screws securely.
Connect plug, press switch for intermittent or continuous operation.
Adjust blade cutting angle for efficiency when tool is unloaded.
Select speed using the control based on material, width, and blade spec.
Disconnect power, loosen base plate screws, adjust angle, tighten screws.
Connect dust collector to the jigsaw for dust removal during operation.
Use fine-tooth blades for wood sheets, clamp work pieces, avoid balancing action for tight curves.
Use parallel guide for defined straight cuts, or cut slowly along a marked line.
Cut slowly along a marked line for fine finish, use a circular guide for perfect circular cuts.
Keep tool dust-free, clean with dry cloth, keep vents clear, check cable.
Service only at TRUPER Authorized Service Center to avoid injury and voiding warranty.
Check and replace worn carbon brushes at an authorized center using original parts.
Regularly apply lubricant to the roller guide for proper blade slippage during cutting.
Select the correct blade for the material to reduce injury risk and improve speed.
Verify no nails/screws on cutting line and clamp the workpiece securely.
Hold tool by insulated grips, use vice for workpiece, keep hands away from cutting area.
Remove tool from workpiece only when stopped. Avoid stopping blade by side force.
Loosen screws, insert blade fully into support, tighten screws securely.
Connect plug, press switch for intermittent or continuous operation.
Adjust blade cutting angle for efficiency when tool is unloaded.
Select speed using the control based on material, width, and blade spec.
Disconnect power, loosen base plate screws, adjust angle, tighten screws.
Connect dust collector to the jigsaw for dust removal during operation.
Use fine-tooth blades for wood sheets, clamp work pieces, avoid balancing action for tight curves.
Use parallel guide for defined straight cuts, or cut slowly along a marked line.
Cut slowly along a marked line for fine finish, use a circular guide for perfect circular cuts.
Keep tool dust-free, clean with dry cloth, keep vents clear, check cable.
Service only at TRUPER Authorized Service Center to avoid injury and voiding warranty.
Check and replace worn carbon brushes at an authorized center using original parts.
Regularly apply lubricant to the roller guide for proper blade slippage during cutting.
General| Model | CALA-A3 |
|---|---|
| Category | Power Tool |
| Brand | Truper |
| Type | Angle Grinder |
| Power Source | Electric |
| Voltage | 120V |
| No-Load Speed | 11000 RPM |
| Spindle Thread | 5/8 - 11 UNC |
| Weight | 4.4 lbs |
| Disc Diameter | 4 1/2 inches |
To Next Page
