Need help?Do you have a question about the Truper PIPI-400 and is the answer not in the manual?
Maintain a clean work area, keep distance, stay alert, and use personal protective equipment.
Avoid hazardous environments, ensure guards are in place, secure workpiece, and dress properly.
Disconnect air hoses, avoid accidental starts, service tool, and never leave unattended.
Use safe materials, avoid flammable substances, and check manufacturer specifications for safety.
Do not use in enclosed or explosive areas; consider wind; ensure adequate ventilation and no ignition sources.
Never point sprayer at others, ensure no steam solvent absorption, and pause correctly if needed.
Clean the gun perfectly after use to remove residue and avoid warranty cancellation.
Adjust paint viscosity using a flow cup and recommended thinner ratios for optimal application.
Mount the cup on the gun, pour thinned coating material, and close the cap securely.
Adjust fluid volume with screw (A) and mist breath with nut (B) for desired spray pattern.
Maintain gun parallel, use even strokes, control speed, apply thin layers, and avoid tilting.
Clean the gun thoroughly after each use with solvent, disassemble parts, and reassemble correctly.
Use special care when adjusting the needle seal with wrench (B) and check for damage periodically.
Maintain a clean work area, keep distance, stay alert, and use personal protective equipment.
Avoid hazardous environments, ensure guards are in place, secure workpiece, and dress properly.
Disconnect air hoses, avoid accidental starts, service tool, and never leave unattended.
Use safe materials, avoid flammable substances, and check manufacturer specifications for safety.
Do not use in enclosed or explosive areas; consider wind; ensure adequate ventilation and no ignition sources.
Never point sprayer at others, ensure no steam solvent absorption, and pause correctly if needed.
Clean the gun perfectly after use to remove residue and avoid warranty cancellation.
Adjust paint viscosity using a flow cup and recommended thinner ratios for optimal application.
Mount the cup on the gun, pour thinned coating material, and close the cap securely.
Adjust fluid volume with screw (A) and mist breath with nut (B) for desired spray pattern.
Maintain gun parallel, use even strokes, control speed, apply thin layers, and avoid tilting.
Clean the gun thoroughly after each use with solvent, disassemble parts, and reassemble correctly.
Use special care when adjusting the needle seal with wrench (B) and check for damage periodically.
General| Brand | Truper |
|---|---|
| Model | PIPI-400 |
| Category | Paint Sprayer |
| Language | English |
To Next Page
