11
Ensure when you turn on the security system the anti-tamper switch of the siren is well pressed and that
the motion sensor is securely mounted onto the holder.
A
Press the ON switch in the App or ON on the remote control to turn the security system on. The switch
will open and become green, the status will change to “Checking Sensors”. All sensors will be checked.
When a sensor is checked and it works the active icon will be displayed next to the sensor and the status
will change to “Walk-out time”.
Walk-out time: During the walk-out time the sensors will not activate the system until after ~ 85 sec. After
~ 85 seconds the status will change to ON and the system will be active.
B
Press the OFF switch in the App or OFF on the remote control to turn o the security system. The switch
will close and the status will change to “Security System disabled.” All sensors will show the inactive icon.
The system and the sensors will not respond if they are opened.
1.3 Turn the security system ON/OFF
A
B
To Next Page
Loading...
