Need help?Do you have a question about the Trust Start Series and is the answer not in the manual?
Turn off mains power before installation or removal of the product.
Ensure wires are stripped to 5mm and no exposed wires are visible.
Switch mains power ON before proceeding with installation.
Activate pairing mode, send signal, and confirm code storage.
Place the receiver in the ceiling box and ensure accessibility.
Control lights wirelessly using transmitter ON/OFF signals.
Delete a specific transmitter code by sending an OFF signal.
Erase all stored transmitter codes by pressing the Connect button.
Turn off mains power before installation or removal of the product.
Ensure wires are stripped to 5mm and no exposed wires are visible.
Switch mains power ON before proceeding with installation.
Activate pairing mode, send signal, and confirm code storage.
Place the receiver in the ceiling box and ensure accessibility.
Control lights wirelessly using transmitter ON/OFF signals.
Delete a specific transmitter code by sending an OFF signal.
Erase all stored transmitter codes by pressing the Connect button.
General| Brand | Trust |
|---|---|
| Model | Start Series |
| Category | Accessories |
| Language | English |
To Next Page
