Trust Wireless Tablet Series - Installing the Software; Using the Tablet; Installing the Driver

TRUST WIRELESS TABLET SERIES
2
NOTE: Install the driver before connecting the tablet.
4.1 Installing the driver
Read the Quick Installation Guide for instructions on how to install the driver.
5 Installing the software
Corel Painter Essentials is a drawing program which you can use with your Trust
Tablet. The drawing program is on a separate CD-ROM.
5.1 Installing Corel Art Dabbler
NOTE: Make sure all other programs are closed during the installation.
NOTE: In the example, the CD-ROM drive is indicated by “D:\”. This may be
different for your computer.
1. Insert the Trust installation CD-ROM into your CD-ROM drive. The drawing
program will start automatically. If it does not start automatically, carry out
the following.
a) Select 'Run' from the start menu.
b) Type [D:\English\Setup.exe] to install the program in English,
[D:\German\Setup.exe] to install the program in German or
[D:\French\Setup.exe] to install the program in French.
2. Follow the on-screen instructions.
3. After the files have been installed, click ‘Finish’ to complete the installation
process.
6 Using the tablet
NOTE: Remove the pen/mouse from the work area if you use a different mouse
(serial, PS/2 or USB).
6.1 Configuring the work area
Click the tablet icon in the right-hand corner of the taskbar. Figure 1 will appear.
A
For selecting the measurement unit (inches or
centimetres).
B For selecting the tracking mode.
6.1.1 Tracking mode
Pen (Absolute): The position of the cursor is the same for both the tablet and the
monitor.
Mouse (Relative): A small movement on the tablet produces a big movement on the
monitor. This can be used to increase the size of the work area by, for example,
using two monitors.