3
Two other brackets are fastened by the help of fasteners at the appropriate
distance on the wall parallel to the floor(At least 1.8 m from the floor and at least
0.5 m from the ceiling).
④Join the brackets on the heater with the brackets, fastened on the wall, with help
of figured screw-nuts.Install the heater under necessary angle(in the direction to the
area being heated). Look at issue 4:(Main rules of heater using).
⑤Electric wiring for the heater has to be done by the qualified specialist.
OPERATING INSTRUCTIONS
A. These appliances must be supplied with proper voltage and frequency
(AC120V, 60Hz), and connected to an individual, properly grounded branch
circuit, protected by a circuit breaker which in accordance with wiring rules.
Power cord of this appliance must be fastened with the chain, installation can
only be carried out by qualified person in order to avoid a hazard.
B.Only operate the heater when it is mounted on the wall. The Electric Infrared
Heater have three heat settings (500/1000/1500W) that could be controlled by
the remote control. The rocker switch on the heater head is used to control the
To Next Page
Loading...
