Need help?Do you have a question about the TSCHORN 3D-Tester and is the answer not in the manual?
General| Brand | TSCHORN |
|---|---|
| Model | 3D-Tester |
| Category | Measuring Instruments |
| Language | English |
Move tester to edge until large indicator moves, then to '0'.
Mount tester in spindle, turn off coolant and spindle.
Ensure measurement is perpendicular, otherwise errors occur.
Move tester to surface until large indicator moves, continue to '0'.
Approach surface until large pointer moves, continue to '0'.
Check correct function and movement of the probe unit.
Verify correct function and movement of the measuring unit.
Check correct function and movement of the dial.
Check small indicator at -1.5 and large indicator at 50 +/- 1.
Insert 3D-Tester into spindle, turn off coolant.
Insert 3D-Tester into spindle, turn off coolant.
Move tester to edge until large indicator moves.
Move along edge to check parallelism in X, Y, or Z axes.
Move along edge to check parallelism in X, Y, or Z axes.
Check correct function and movement of the probe tip.
Check correct function and movement of the dial.
Check correct operation and movement of the probe tip.
Move tool to probe tip in X or Y until indicators show '0'.
Determine reference length for Z-axis.
Move tool to probe surface until large indicator moves.
Continue until both indicators show exactly '0'.
To Next Page