TSI Incorporated 3480 User Manual (English)

Questions and Answers:

D
Dustin StanleyAug 1, 2025
What to do if TSI Incorporated Inverter electrospray is dripping?
- P
  phillip17Aug 1, 2025
  If the electrospray is operating in dripping mode, or the current display is much lower and more unstable than normal, consider the following actions: * Increase the voltage setting. * Increase the capillary pressure drop. * Increase the air flow rate. * Purge the capillary. * Clean the capillary tip. * Adjust the position of the capillary. * Clean the inlet fitting. * Increase the conductivity of the sample.
J
Jessica JimenezAug 6, 2025
What to do if TSI Incorporated Inverter electrospray is pulsating?
- J
  John LiAug 7, 2025
  If the electrospray operates in pulsating mode, or the current display is lower and more unstable than normal, try these solutions: * Increase the voltage setting. * Increase the capillary pressure drop. * Purge the capillary. * Clean the capillary tip. * Adjust the position of the capillary. * Clean the inlet fitting. * Increase the conductivity of the sample.
J
James HobbsAug 11, 2025
What to do if TSI Incorporated Inverter electrospray is in corona discharge mode?
- A
  amy14Aug 11, 2025
  If the electrospray is operating in the corona discharge mode, or the current display is higher and more unstable than normal, consider the following: * Decrease the voltage setting. * Decrease the capillary pressure drop. * Increase the CO flow rate. * Purge the capillary. * Clean the capillary tip. * Adjust the position of the capillary. * Clean the inlet fitting. * Decrease the conductivity of the sample.
J
jasonvaughnAug 16, 2025
Why is there no current reading on my TSI Incorporated Inverter?
- M
  myerskariAug 16, 2025
  If there is no current reading, ensure that the voltage, pressure, and flow rates are adjusted properly. Also, verify that the capillary and the platinum wire are immersed in the sample vial solution.
W
William SmithAug 21, 2025
How to fix no liquid flowing through TSI Incorporated Inverter capillary?
- K
  Katie AlvarezAug 21, 2025
  If no liquid is flowing through the capillary, make sure the voltage, pressure, and flow rates are adjusted properly, and ensure that the capillary is immersed in the sample vial solution.
C
colleenbrownAug 27, 2025
How to fix broken TSI Incorporated Inverter capillary tip?
- M
  Mr. Raymond JohnsonAug 27, 2025
  If the capillary tip has become broken during maintenance or handling procedures, replace the capillary.