Need help?Do you have a question about the TSI Incorporated portacount pro 8030 and is the answer not in the manual?
General| Model | PortaCount Pro 8030 |
|---|---|
| Type | Respirator Fit Tester |
| Concentration Range | 0 to 100, 000 particles/cm³ |
| Light Source | Laser Diode |
| Battery Life | Up to 8 hours |
| Humidity Range | 0 to 95% RH, non-condensing |
| Power | AC adapter or rechargeable batteries |
| Operating Temperature | 10 to 35 °C (50 to 95 °F) |
| Storage Temperature | -20 to 60 °C (-4 to 140 °F) |
| Data Storage | Internal memory for test results |
| Display | Color touchscreen |
| Communication Interface | USB |
| Compliance | CE |
Details how to fit test disposable respirators using probes and the TSI Model 8025-N95 Probe Kit.
Provides step-by-step instructions and warnings for installing a probe into a disposable respirator.
Details the initial setup, including filling the alcohol cartridge and warnings.
Guides on connecting a flash drive for database selection and saving data.
Explains the importance and procedure for performing daily maintenance checks on the instrument.
Provides instructions on performing the actual fit test, including subject preparation and exercises.
Details how to record fit test results, whether manually or via database.
Differentiates between External Control (FITPRO software) and Stand-alone modes.
Recommends annual recalibration and provides contact information for service.
Lists common symptoms, their possible causes, and recommended solutions.
Explains the principle of measuring respirator fit by comparing particle concentrations.
Details the formula and method used to calculate the fit factor.
To Next Page
