-7-
Reviewing Data
1. Use the Data screen to review data that has been
collected. Use the scroll bar (slide) on the right to
scroll though the records.
2. The record number is displayed near the bottom of
the screen. As each record is selected, its data and
relevant parameters are displayed.
3. Descriptions of each section of the data display
screen are given in the following table.
Data Screen Labels and Controls
Button used to change between counts and
concentration displays.
Differential concentration.
Cumulative concentration.
Export the data to a flash drive.
Print data to the optional printer.
Zone in which the data was collected.
Location within the Zone.
Date on which the data was collected.
Time at which data collection was initiated.
Duration of the sampling period.
Volume of air that was sampled.
Alarm threshold was triggered (Yes) or not
(No).
Status of the instrument hardware. OK if no
issues or an error abbreviation if instrument
has a possible issue.
Temperature at the end of the time the data
was collected (if optional probe was
connected during sampling).
Data Screen Labels and Controls
Humidity level at the end of the time the data
was collected (if optional probe was
connected during sampling).
Velocity of the ambient air at the sampling
location as measured by a connected TSI
Velocity probe (optional).
The record number of the sample being
displayed.
Instrument Configuration
Select the Setup tab page and tap the Device button to
get to the Device Setup page from which you can
access screens that allow you to set or change the date
and time, calibrate the touchscreen display, set up
communications, make regional selections, or get to the
Service screen.
To Next Page
Loading...
Need help?
General
