TTC FIREBERD 6000A User Manual

Part 7 liar^ 72: Frame Relay (COIW
TX
HEADER
Dm
MORE
CLRALL
A
LOAD
FIW)
A
LENGTH
A
Access the PRAME lllANSMlT menu.
Access the
HBADBR menu.
Access the
WSMlT DLCI menu.
See additional selections.
Clear all pmiously set transmit DKIs Use the keypad to select
the DLCI frames
!a transmit over. Ress BNlBR to set the due.
Press the
A (up-arrow key) on the keypad tdce to retum to
the
FRAME TRANSMIT menu.
Access the
FRAME LOAD menu.
Use the
keypad to set the transmit frame rate (in kWs) to 10% of
the line rate.
Press ENTER to set the due. NO11I: This due
may cbrmge basedon your conJpration.
Press the
A (up-arrow key) on the keypad Me to return to
the
FRAME TRANShUT menu.
Use the keypad
!a set the transmit frame minimum and maxi-
mum length (in units of octets). Press ENlER to set the dues.
Press the
A (up-armw key) on the keypad tdce to return to
the
FRAME REULY main menu.
1 Part 2 - Performing the Test
1 Press RESTART to dear alms and begin the test. Verify that:
A. FTREBERD 6000's PATIERN SYNC LED is illuminated (indicating that the HREBERD 6000 is receiving valid
frame relay frames).
" W- *-
W Address: hup://www.nc.com
lTC Technical Support
1-800-638-2049
0 1997 Teleeommuni~ons Techniques Corpomtion. M rights rmmd.
WOO-Fr.Relay.0~1-Service/Cudl. 1/3.97
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

TTC FIREBERD 6000A Specifications

General

Brand	TTC
Model	FIREBERD 6000A
Category	Test Equipment
Language	English