TTC FIREBERD 6000A User Manual

FImBERD 6000 Application
Frame Relay End-to-End
Connectivity Test
Frame Rday End--End
Connectivity Application
PaH 1 - Verify Pmper Ransmission of Frames
ERROR IOST FRM Result should equal zero. If mult is incrementing, then frames are being disd
kthe network. Possible
causes oflostfnmes: (1) there are bit errors at the physic4
&, or (2) there is congestion in the swnching network - frames are dropped.
mWICNT
Result should rapidlyincrement, iodicating
valid test ha are being received.
If not, the farad ElREBERD 6000 is not transmitting test frames or the switching
network is not con6gured pmperiy.
PERFORMANCE AVGm
Should compand to the FIXED race being transmined by the fu-end mReBERD
6000 (assuming this 6xed race is below the near-end line me).
AVG%LlTL
Result should equal 10% (assuming both ends have equal line rates and the frame
relay
transmit rate is equal to 10% of the line rale).
(continued on back)
TTC Technical Support
1-800-638-2049
FB6000-Er.Relay.Eod2End/CudI1 U3.97
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

TTC FIREBERD 6000A Specifications

General

Brand	TTC
Model	FIREBERD 6000A
Category	Test Equipment
Language	English