TTC FIREBERD 6000A User Manual

Frame Relay IP ping Test
TbefoUauingpmu?dure artliw bow to use tk PI- 6000 to ma end-to-endconnecttvity of a nsw WCvia n in-service
PPfng test. Fkse Please tk entireprocedure BERXW startin#.
M C
Frame Relay IP Ping
Test Application
I Part 7 - Verify Ping Echo 7PansmissionlPfvper Echo Reply Response
Conjgure tk FIREBERD 6000 forfmme re@ testing according to tk PIREBERD 6000hmw uekry aping Schrp cal.
ERROR M PNG
Result should increment. If not, your mReaERD 6000 is not trylsmitting Ping
packets.
ECHO PNG
Result should increment. If not, the farad device may not be sending Ping packets
success^ lo your PIREEIERD 6000.
UISI PNG
Result should not increment. If so, your IIREBERD 6000 is not receiving proper
echo replies in response to hansmitled Ping echo packets.
I
Part 2 - Determine Roundtrip Delay Throughout the Network
Monitor tk fouoruing mid&:
F'EWORMANCB MINPNG
Minimum lime laken for a Ping echo packet lo he hansmitled and an echo
reply received.
MAX PNG
Maximum time taken for a Ping echo packet to be transmitted and an echo
reply received.
AVG PNG
Average lime taken for a Ping echo packet to be transmitled and an echo
reply received.
@ 1997 Telecommunicsions TecMques Carpontion. M rights resened.
TTC Technical Support
1-8OO-638-2OM
W6000-Pr.Relay.Pi~.TesVCardl.1/3.97
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

TTC FIREBERD 6000A Specifications

General

Brand	TTC
Model	FIREBERD 6000A
Category	Test Equipment
Language	English