TTulpe B-6 P37 Eco - User Manual

Questions and Answers

G
gsmithAug 3, 2025
What to do if my TTulpe B-6 P37 Eco Water Heater smells like gas?
- L
  Laurie GreenAug 3, 2025
  If you smell gas from your TTulpe Water Heater, it might be due to a gas leak in the tubes. In this case, it's crucial to avoid using electrical switches or anything that could create sparks nearby. The smell could also indicate an obstruction in the flue gas circuit. Inspect the smoke channel and flue gas conduit to ensure they are working efficiently. Another possible cause is excessive gas consumption, so check and regulate the gas flow.
N
nataliethomasAug 7, 2025
Why is there no spark in my TTulpe B-6 P37 Eco Water Heater?
- C
  Chad SandovalAug 7, 2025
  If your TTulpe Water Heater isn't sparking, several issues could be at play. First, check the battery; it might be exhausted and need replacement. Ensure the device's electrical cable is properly connected. A broken electrical card could also be the culprit, requiring testing and potential replacement. Insufficient water pressure can also prevent a spark; repair the device to ensure adequate pressure and rotate the selector knob fully to the right. Finally, inspect the membrane and electrode, as either could be damaged and in need of replacement.
C
cherylhendrixAug 11, 2025
What to do if the burner does not switch off when the water turns off in TTulpe B-6 P37 Eco?
- D
  Daniel HenryAug 11, 2025
  If the burner on your TTulpe Water Heater doesn't switch off when the water is turned off, it could be due to grime on the gas shutter, which requires cleaning. Alternatively, the valve piston or stem might be stuck in the open position; try disassembling and cleaning it, and replace if necessary. Another possibility is a micro lever locked in the open position, which needs testing. Also, if you're using an LPG supply, examine the gas pressure and adjust it, replacing the tank pressure regulator if needed.
C
christopher84Aug 15, 2025
Why does the pilot not switch on when there is a spark in my TTulpe B-6 P37 Eco?
- G
  george53Aug 15, 2025
  If the pilot light on your TTulpe Water Heater doesn't ignite when there's a spark, the safety device might be broken and need replacement. Also, ensure that the gas tap is open and that there is a sufficient gas supply. If there's air in the gas tubes, release the gas to resolve the issue.
N
Nicole AdamsAug 20, 2025
How to fix TTulpe B-6 P37 Eco Water Heater that shuts off after several minutes?
- C
  Corey MorenoAug 20, 2025
  If your TTulpe Water Heater shuts off after a few minutes, it could be due to an improperly connected flue pipe, too many bends in the flue, or insufficient draw. To resolve this, mount a flue pipe with enough vertical length.
B
bjonesAug 25, 2025
Why does the exchanger blade become dirty quickly in TTulpe Water Heater?
- D
  Donna GallagherAug 25, 2025
  If the exchanger blade in your TTulpe Water Heater is getting dirty quickly, it could be due to poor draught or dusty conditions. Check the efficiency of the smoke channel. A yellow flame can also cause this issue, so check the gas type and clean the burner. Also, excess gas consumption may be the reason, thus check and regulate it.
A
Adam CoxAug 28, 2025
What to do if TTulpe B-6 P37 Eco smells like gas?
- H
  Hayley BeardAug 28, 2025
  If you smell gas from your TTulpe Water Heater, it could be due to gas loss in the tubes; inspect the tubes to locate the leak. Remember not to activate any electrical switches or anything that produces sparks in the area.