Need help?Do you have a question about the Tube-Town LND150 FX-Loop and is the answer not in the manual?
Active effect loop retrofit kit for guitar/bass tube amplifiers, powered by amplifier's supply voltage.
Disclaimer on liability for use/installation errors. Installation must be by qualified personnel only.
Module operates with potentially fatal voltages. Not for beginners; requires schematic reading & high voltage experience.
Details input signal levels (InB/InA), maximum input, and supply voltage range (250-400 VDC).
Visual guide to PCB layout, component placement, and connection points for signal and power.
Physical dimensions of the FX-Loop PCB (84.00 mm x 56.00 mm) for chassis mounting.
Illustration showing recommended spacing for mounting components or the PCB itself.
Advice on adjusting the input voltage divider for optimal performance and signal level.
Table of resistor combinations for input voltage divider, resulting ratios, and note on optional capacitor C7.
Example installation of the FX-Loop between tonestack and master volume in an 18 Watt amplifier.
Example installation of FX-Loop before master volume in a Jim HP amplifier, recommending R14 values.
How to implement true bypass for the FX-Loop using a switch or relay kit when the loop is not in use.
Instructions for rewiring the FX-Loop for parallel operation, mixing dry and effect signals, with phase note.
General| Brand | Tube-Town |
|---|---|
| Model | LND150 FX-Loop |
| Category | Control Unit |
| Language | English |
To Next Page