Radio Remote Controller Instruction
LD-1C RTT & LD-5C RTT
/ / .
Read the safety instructions on the enclosed sheet carefully before you start installation.If these instructions are
not followed,manufacturer’s industry liability and warranty are void.
is not liable for any change in the regulations and standards introduced following the publication of
this manual. hereby declares that the short range product complies with directive 1999 5 CE
This product must be installed and programmed by qualified personnel.
Manufacturer
Manufacturer
Warning
The Remote Control is a short range emitter radio control device for various applications such as blinds shutters
projection screens awnings and more.
, ,
,
1.Product Description
2.Technical Information
.Frequency:433.92 MHz
.Temperature:-10 to +50
. attery Type:CR2032 Lithium 3V
.For indoor use only
℃ ℃
B
The Remote Controls are able to
control up to 5 groups of motors
radio motors or motors equipped
with radio receives
(
). Either 1 motor
or 1 group of motors(1C) or 5 motors
or 5 groups of motors(5C).
3.Functions
LD-5C RTT
LD-1C RTT
127mm
23mm
44mm
= .433 92MHz
50m
= .433 92MHz
5m
[ ]: ( )
( )
( )
a UP control key
b STOP control key
c DOWN control key
d LED
e
f
[ ] :
[ ]:
[ ] :
[ ]:
[ ] : ( )
PROG
Selection key LD-5C RTT
[ ]a
[ ]b
[ ]c
[ ]d
[ ]e
[ ]f
[ ]a
[ ]b
[ ]c
[ ]d
[ ]e
4.Open the emitter Replace the battery/
. .
.
.( )
. .
1) Use a screw driver to open the back cover
2) Remove the old battery and place the new
battery CR2032 Lithium 3V
3) Use a screw driver to close the back cover
LD-1C RTT & LD-5C RTT
Tube 1 Channel Remote & Tube 5 Channel Remote
www.tubemotor.com.au
To Next Page
Need help?
General