3、 Hav
e one person lift the tent, while another person slides the piece over the cross
bar, so that one bolt is on each side of the cross bar
4、 Take the bottom bracket and fit it under your cross bar so that the bolts go through
both holes on either side.
5、 Attach one nut on each bolt and tighten them using a 13mm wrench. IMPORTANT:
Tighten two bolts simultaneously so the pressure is equal on both sides.
6、 Repe
at process 2-5 on all 4 corners
IM
PORTANT: AFTER INSTALLING THE TENT ON YOUR VEHICLE, MAKE SURE THAT
EACH BRACKET IS SECURELY FASTENED. SHAKE THE TENT TO INSURE IT WILL
NOT MOVE- CHECK TENT AFTER DRIVING A SHORT DISTANCE TO ENSURE THE
TENT HAS NOT SHIFTED ON THE ROAD
OPENING THE HARD SHELL
1、 Unlock the fastening soft strap, push the button and release the reinforced strap
To Next Page
Loading...