1.
Slide the 35mm M8 Bolts into the inner slot in the center of the mounting tracks until they are
aligned with the holes in the mounting tracks and the base.
INSTRUCTION 1 PICTURE
INSTRUCTION 3 PICTURE
3.
Using the supplied 35mm bolts M8, add steel washers to each bolt. Slide your hand between base and
mattress and and hold nut in place. The bolts should pass through the holes in the tent base and the
mounting tracks. Reach under the mattress and tighten the nuts firmly using the supplied ratcheting 13 mm
wrench.
To Next Page
Loading...