Tumble Star Air Track User Manual

Safety Instructions
These instructions apply to all inflatable products from Tumble Star. Air Products are
designed as training equipment for gymnastics, cheerleading, tumbling, school sports,
show groups, martial arts, parkour, free running and tricking.
1. Never use a damaged Air Product.
2. Do not wear shoes while on an Air Product and keep your pets away from your air
products for they may damage or scratch the surface.
3. Never place an Air Product near overhead obstructions, such as trees or power lines,
nor place the equipment on a slope. The area on which the Air Product is placed must be
clean, dry, flat and free of obstacles.
4. Always set up the Air Product in the same area where you will be using it. When
repositioning the Air Product, do not drag it. Lift it by the handles and avoid scraping.
5. Do not bring any sharp items on or close to the Air Product.
6. Avoid jumping or landing closer than 20 cm to a valve.
7. Assure that the Air Product has sufficient air pressure to avoid injury. Recommended air
pressure levels can be found in this user manual.
8. Do not use the Air Product without using landing mats on both ends. For safety reasons,
also position landing mats on the sides.
9. Do not use the Air Product in the rain. While inflating the equipment, electrocution may
occur and also the surface will be slippery which can cause injuries.
10. Do not expose Air Products to heat, including heat from long exposure to the sun.
11. When setting up the Air Product outdoor, use a groundsheet to avoid damaging the Air
Product.
12. Never pack, store or transport the Air Product when it is wet.
13. The Air Product is cleaned with water and soft soap. Do not use industrial cleaning
products.
14. Never leave an Air Product outside unattended and keep the air pressure under the
maximum values described in this guide.
15. Be aware that Air Products are not designed as landing mats.

Tumble Star Air Track Specifications

General

Brand	Tumble Star
Model	Air Track
Category	Fitness Equipment
Language	English

Summary

Safety Instructions

Avoid Damaged Products

Never use the Air Product if it is damaged to prevent potential injuries.

Surface Protection

Do not wear shoes or allow pets on the Air Product to prevent surface damage.

Safe Setup Environment

Place the Air Product in a clean, dry, flat area, free from overhead obstructions and slopes.

Proper Repositioning

Keep Sharp Objects Away

Do not bring any sharp items on or close to the Air Product to prevent punctures.

Valve Landing Clearance

Ensure Adequate Air Pressure

Verify sufficient air pressure for safe use; refer to the manual for recommended levels.

Mandatory Landing Mats

Always use landing mats on all ends and sides for safety reasons.

Avoid Rain Usage

Do not use the Air Product in the rain due to electrocution risk and slippery surfaces.

Heat and Sun Exposure

Outdoor Groundsheet Use

Wet Storage Prohibition

Unattended Use and Pressure

Set-up Instructions

Location and Ground Cover

Pick the right location, free from debris, and use a ground cover if outdoors.

Inflation Process

Pump up the track to a minimum of 1 psi or your desired pressure level.

Secure Valves After Inflation

Packing Your Air Product

Deflation and Folding

Fold to Bag Width

Tight Rolling for Transport

Secure Valve Caps

Problem Solving

Addressing Air Leaks

Repairing Punctures

Guide to repairing holes using soapy water, adhesive, and a repair patch kit.