Tunstall Keypad - Advanced Operations (Vi;Vi+ only); Unit Configuration Templates; Save Template into Keypad Memory; Write Template to Home Unit

Advanced Operations (Vi/Vi+ only)
Unit Conguration Templates
Up to four conguration “templates” of customised
settings can be stored in the keypad’s memory for
subsequent programming to other home units.
This function must be used with care. Specic settings
such as unit ID, radio trigger assignments/
congurations, personal recipient/auto-answer
numbers etc must be individually congured after
any template is applied.
Only settings able to be congured by service
providers and which have been changed from their
default values are stored/overwritten, though radio
peripheral and unit identities are unaffected. A stored
template should only be applied to home units of the
same model and release level as the unit from which
it was read otherwise a warning will be given and the
process halted.
Save Template into Keypad Memory from home unit
Press followed by destination template ( - )
held for 3 seconds, then .
Write Template from Keypad to home unit
Press followed by source template ( - ) held
for 3 seconds, then .
List Stored Templates
Pressing lists the home unit software version
associated with each stored template.
Delete Template from Keypad
Press followed by source template ( - ) held
for 3 seconds, then .
Frequently used codes
Please refer to home unit programming
documentation for full details.
ID (Vi/Vi+ only)
To add: 1-4 Unit ID (max 12 digits)
Delete specic: 1-4
Delete all
Monitoring Centre Numbers (Vi/Vi+ only)
To add: 1-4 Tel. No. (max 16 digits)
( within number is used to represent
a dialling pause)
To make test call: 1-4
Time/Date (Vi/Vi+ only)
HHMM(24hr format)
DDMMYYYY
Speak time/date:
(Vi+ only)
Volume Setting (Vi/Vi+ only)
Clear display using key.
Press or to select desired volume.
Press key within 10s to store the new level.
Battery Test (Vi/Vi+ only)
Clear display using key. Press the key.
Good battery = three ascending tones.
Bad battery = single low pitched tone.
Resetting Conguration Defaults
All except radio triggers, time/date:
All except time/date:
Selecting STMF or DTMF
Auto-select STMF/DTMF: (default)
Only use DTMF:
Only use STMF:
Note: Before using STMF, the PNC monitoring centre
and back-up centre must be congured to receive
STMF
Personal Trigger Test Reminder (Vi/Vi+ only)
Demo Test Reminder messages:
Part Number D5107226B
To print a larger version of this document
please visit www.tunstall.com
Designed and Manufactured in the United Kingdom by
Tunstall Healthcare (UK) Ltd,
Whitley Bridge, Yorkshire.