Quick reference guide for Lifeline Digital (022-25-9xx)
Yellow Extra button Green Cancel but-
ton
Red Alarm button
Enable programming mode:
a) Press and hold the green Cancel button, then press
and hold the red Alarm button and the yellow Extra
button.
b) Release all buttons when the device emits a rising
sound signal and announces "Programming mode",
The LED indicators start chaser sequence and the
button LEDs flash in unison.
c) You can now:
• Adjust speaker volume
• Adjust LED
•
Activate Radio test mode
• Check cellular signal
• Connect a peripheral
• Disconnect a peripheral
Adjust speaker volume:
a) Press and hold the yellow Extra button.
b) When the device announces "One", release the but-
ton.
c) Adjust speaker volume:
• Press the red Alarm button to increase volume.
• Press the yellow Extra button to decrease volume.
d) Press the green cancel button to save settings and
exit.
Adjust LED intensity:
a) Press and hold the yellow Extra button.
b) When the device announces "Two", release the but-
ton.
c) Adjust LED intensity :
• Press the red Alarm button to increase LED intensi-
ty.
• Press the yellow Extra button to decrease LED in-
tensity.
d) Press the green cancel button to save settings and
exit.
Radio test:
a) Press and hold the yellow Extra button.
b) When the device announces "Three", release the
button.
c) When the device announces "Radio test mode Acti-
vate transmitter now", activate/trigger the peripheral
you want to test:
Connected and battery is OK.
Not connected and battery is OK.
Connected but battery is low.
Not connected and battery is low.
d) Press the green cancel button to exit.
346 80 21-61. V 01. R 06.2021. 1 © 2021 Tunstall Group Ltd.
To Next Page
Need help?
General
