Tunze 7097 - Practical Settings - Wave Motion; Pulse Only Wave Motion Simulation

94 95
Settings in practice
Before rst use, please check the proper attachment of the pumps / Wavebox in the aquarium!
Position the pumps in the aquarium in such a manner, that the settings do not cause any water damages on the
Multicontroller due to strong current!
Prior to the adjustment, we recommend a synchronization of the Multicontroller 7097 time with the computer. For this,
click on the “light control“ eld, and in the eld “real time clock“ click on the “sync with PC” button. The real time in the
computer is now displayed in this eld.
“pulse only“ – wave motion simulation
The pulse operation generates biologically active current pulses (= waves) which simulate a natural wave motion.
The greater the difference between the specied pump performances, the greater the wave character of the current
ow will be.
In the eld of “mode“, click on the “pulse only“ button.
In the eld “power control“, the pump performance can be set to “low power“ and “high power“ by clicking on “channel“
in the channels 1 to 4. The number zero “0“ means pump not operating. The lowest possible setting is 20%, and the
maximum adjustable setting is 100%.
The pulse frequency “pulse ow“ can be set from 0.3 to 8.0 sec. This pulse frequency is very accurate, and can also
function as a Wavebox controller (Wavecontroller).
Ramping function (swelling): the “ramp” setting can be used to program a soft start of the pumps (reduces the pumps
sounds). The ramp time cannot be selected greater than the “pulse ow” time.
Surf current ow “random ow“: a clicking will cancel the setting “pulse ow“, and the pumps will function according
to a random variable pulse operation between 0.5 and 3.5 seconds to reproduce a typical surf.
Up to four pumps can be connected directly. With two Y-adapter cables 7090.300 an extension up to eight pumps
will be possible.