100 101
An example for “interval“:
Outputs 1 and 2, “low power” at 20% and “high power” at 80%.
Outputs 3 and 4, “low power” at 40% and “high power” at 100%.
Interval “interval time” at 6 hours.
Pulse frequency “pulse ow” to 1.5 sec.
Connect a pump to each socket of the outputs.
Result:
The pumps at the outputs 1 and 2 will operate for 6 hours, and vary their output between 20% and 80%.
After 6 hours the pumps 1 and 2 will be switched off, and the pumps 3 and 4 will continue to operate and vary their
performance between 40% and 100%.
After 6 further hours, the pumps 1 and 2 will switch on again, etc.
If the night mode function “night mode” is enabled, this will interrupt the pulse operation for the programmed time
interval, for example, from 9:00 p.m. to 9:00 a.m., during which all pumps will remain in the “low power” setting, but the
high and low tide simulation “interval” will continue to function. In the morning after 9 a.m., the selected pulse operation
of the pump will then start.
To Next Page
Loading...
