Turbosol UNI 30 D - User Manual

Questions and Answers

P
Patricia YoungAug 4, 2025
Why does mortar not come out of my Turbosol UNI 30 D Paint Sprayer gun?
- D
  David HuynhAug 4, 2025
  If the mortar does not come out of the Turbosol Paint Sprayer, there are several potential causes. First, the spray gun may be blocked, so disassemble and clean it. The mortar hose could also be blocked; locate and remove the blockage. Other possible causes include blockages in the ball valves (remove the inspection plugs and wash the valves), the safety device not being activated (activate it), a bent mortar hose (straighten it), incorrect gear selection (stop the engine and select the correct gear), mortar that is too dry (add water to make it more fluid), or insufficient mortar in the hopper (add more mortar).
J
Jessica ShortAug 12, 2025
What to do if the safety device on Turbosol UNI 30 D activates frequently?
- C
  Carla GonzalezAug 12, 2025
  If the safety device on your Turbosol Paint Sprayer activates frequently, it could be due to several reasons. The mortar might be too dry, so try adding water to make it more fluid. A faulty mix can block the delivery valve, so wash the delivery valve and adjust the mix. Other causes include a blocked mortar hose (find and remove the blockage), a blocked mortar by-pass (clean it), mortar with insufficient cement or lime (check and adjust the mix), a dirty valve group (clean the suction and delivery valve group), or a bent mortar hose (straighten it).
C
Colton MarshallAug 19, 2025
Why does the mortar come out discontinuously from my Turbosol UNI 30 D?
- S
  Steven GarciaAug 19, 2025
  If the mortar comes out discontinuously from the Turbosol Paint Sprayer, it might be due to a blockage in the valves group; remove the inspection plugs and wash the valves. Another reason may be insufficient air supply; in this case, check the efficiency of the compressor, ensuring the filters are clean and the belt is properly tightened. Also, ensure there are no air leaks in the air system or spray gun, and confirm that the air delivery cock is fully open and the air discharge cock is properly closed. Finally, a dirty nozzle can cause this issue, so remove and clean it.
S
stephanie23Aug 27, 2025
How to fix a Turbosol Paint Sprayer pump that does not engage?
- J
  Jill GarciaAug 27, 2025
  If the pump does not engage on your Turbosol Paint Sprayer, the suction valve group might be dirty or blocked, so wash the suction valve group. Alternatively, the ball valves could be dirty or worn, so clean the ball valves, and replace them if they are worn. Also, the valve seats may be dirty or worn; clean them and replace them if necessary.