9
Automatic Transmission
Turbo 350
Turbo 400
700R4
These transmissions require a bushing between the crank and torque converter. Do not
install one of these automatic transmissions without the bushing, failure to do so could
cause serious damage.
Air Cleaner
Never operate this engine without a proper air cleaner installed. We recommend
the use of an “outer wear” for off road applications. To ensure proper operation, clean
your air filter regularly. Throttle body accepts a K&N filter with 4 inch openening.
Break In Procedure
Upon initial start up, verify minimum oil pressure of 20 PSI at 2000 RPM. This is
a new engine and must be properly broken in before high RPM/Load use. We advise
against high RPM/Load use during the break in period. To protect sensitive engine parts
during break in the ECM is programmed to limit the engine RPM as follows…
1
st
hour 4000 R.P.M
2
nd
hour 5000 R.P.M
3
rd
hour 6000 R.P.M
4
th
hour 6000 to 7200 R.P.M depending on application
Check oil before starting engine, check often during break in period. We recommend
the oil and filter be changed after the initial 15 hours of use.
Electrical
The wire harness included with this package has been developed to ensure
maximum reliability and ease of installation. It is imperative that these connections be
made correctly; otherwise serious damage or fire may result.
To Next Page
Loading...
General